You're now going to add the final panels to complete the propagator.
Parts
- 4x small angle bracket
- 8x M5 * 8mm bolt
- 3x M5 * 16mm bolt
- 3x M5 washer
- 3x M5 nylock nut (with plastic insert)
- 3x vent disc
- 1x hinged panel set
Add the panels
- Place the the panel set onto the top of the propagator, with the roof part (with the vent hole) on the top, and the other parts lying down over the front and rear.
- Secure the rear upper panel to the side panels with the angle brackets, nuts and 8mm bolts.
Add the vents
- With 16mm bolts, secure the vent discs to the outside of the side panels and the top of the lid.
- The washers go on the inside, underneath the nylock nuts.
- Tighten until the discs are a suitable tightness.
Your propagator is now complete!
Previous: Step 3 : Fit the LED lights