Propagator assembly : Step 2

Add sides and rear panel

Parts

• 2x side panel
• 1x rear panel (with 16mm hole)
• 2x small angle bracket
• 4x M5 * 8mm bolt
• 4x M5 nut

Process

1. Slot the side panels onto the frame, with the hooked tab facing towards you (front of propagator) on both sides.
2. Ensure the panels are flush with the frame, then tighten the bolts.
3. Slot the rear panel onto the frame, and tighten the bolts. The hole can go either on the left or the right, depending on where you will position the propagator in relation to your power supply.
4. Secure the sides and rear panel with small angle brackets, M5x8mm bolts and nuts.

Previous: Step 1 : Assemble the frame

Next: Step 3 : Fit the lights