To access the sensor control panel (also called Configuration Mode):
Step 1 - Set configuration mode
In configuration mode, the sensor is transmitting a WiFi network which you can connect to. This WiFi network has no internet access, so ignore any "no internet" warnings from your phone.
Wireless humidity sensor
- Open the sensor.
- Press the button under the battery; hold it down until the green LED starts flashing slowly (after 4 seconds), then let go.
- The sensor is now waiting for you to connect to its WiFi network.
- Go to step 2.
Wireless soil sensor
- Press the button on the top; hold it down until the green LED starts flashing slowly (after 4 seconds), then let go.
- The sensor is now waiting for you to connect to its WiFi network.
- Go to step 2.
Step 2 : Connect to sensor wifi
- Connect to the “sensor-ABCD” network on your phone or tablet (where ABCD is a code unique to your sensor).
When connected, you should be prompted to “log into Wifi network” or similar, and be automatically directed to the device control panel.
If you are not redirected to the WiFi setup page when you connect to “sensor-ABCD” then you will need to open an internet browser (eg Safari, Chrome) and go to http://192.168.4.1
Or, if you are viewing this as a printed page, scan the QR code below: